A 3D printable file of a circular base with large brick texture. These bases can be printed in resin but are fast and cheap when printed in FDM, and the texture is noticeable in either material.

A 3D printable file of a square base with large brick texture.

3d printable wall mount for Armada Huge base ships. Align two to hold both halves of the base. Optional 85mm long linkage bar/ruler included. The "Armada Huge Ship: Slightly Smaller" Version holds the ship's base 65mm (2.56 inches) away from the wall, which is 5mm closer to the wall than the original version.

3D printable wall mount for Armada large base ships.

3D printable wall mount for Armada medium base ships.

3D printable wall mount for Armada small base ships.

3D printable wall mount for Armada squadron.

3D printable wall mount for X-Wing huge base ships. Combine two mirrored prints to hold both halves of the base. Inside slots are designed for card storage.

3D printable wall mount for X-Wing large base ship.

3D printable wall mount for X-Wing medium base ship.

3D printable wall mount for small base X-Wing ships.

A 3D printable file for a headphone hook designed to attach to the corner of a computer monitor using the adhesive of your choice (we recommend Command Strips or something similar).

This item can also be ordered made-to-order as an FDM print.

Dimensions:

The hook is 15mm (.6 inch) wide and designed to hold headphones with a headband width of 40mm (1.5 inches) or less. The support bar of the hook has 60mm (2.3 inches) of contact with the top of the monitor, and the hook has 40mm (1.5 inches) of vertical contact with the side of the monitor. This hook comes with an optional cord peg that can be glued to the side of the hook. The peg is 15mm (.6 inch) in total length and 14mm (.5 inch) at its widest. The main body of the peg is 10mm (.4 inch) long and 10mm (.4 inch) in diameter, and the end cap is 5mm (.2 inch) long and 14mm (.5 inch) in diameter.